S UPER P3TDE6/P3TDER User’s Manual Motherboard Features CPU Introduction Single or dual Pentium ® III FCPGA 500 MHz-1.40 GHz FCPGA proces- sors with a 512K L2 cache at front bus speeds of 133 and 100 MHz. Note: Please refer to the support section of our web site for a complete listing of supported processors (http://www.supermicro.com/TechSupport.htm). You must use the server version of the processors mentioned above. Memory Four 168-pin DIMM sockets supporting up to 4 GB of registered ECC SDRAM Note: The memory speed must match the front side bus speed being used.
(Both 133 or 100 MHz.) Also, memory modules must be installed in pairs (first in the two slots of Bank0, then in both slots of Bank1, if needed). Chipset ServerWorks ServerSet III HE Super Light Expansion Slots P3TDE6: P3TDER:
• Two 64-bit, 66/33 MHz PCI slots • One 64-bit, 66/33 MHz PCI • Four 64-bit, 33 MHz PCI slots • One 2x/AGP Pro (ATI 8 MB Rage Graphics Card included) BIOS 4 Mb AMI ® Flash ROM APM 1.2, DMI 2.1, PCI 2.2, ACPI 1.0, Plug and Play (PnP) PC Health Monitoring Seven onboard voltage monitors for CPU core, chipset voltage, +5V and + 12V Fan status monitor with firmware/software on/off control Environmental temperature monitor and control CPU fan auto-off in sleep mode Power-up mode control for recovery from AC power loss System overheat LED and control System resource alert 1-10