Preface Preface About This Manual This manual is written for professional system integrators and PC techni- cians. It provides information for the installation and use of the Super- Server 6011D. Installation and maintainance should be performed by expe- rienced technicians only. The SuperServer 6011D is a high-end dual processor 1U rackmount server based on the SC810 1U rackmount server chassis and the P3TDDR, a dual processor motherboard that supports single or dual Intel Pentium ® III FCPGA 500 MHz to 1.40 GHz and faster processors with a 512K L2 cache and single or dual low power Pentium ® III processors at front side bus speeds of 133 and 100 MHz and up to 4 GB PC266/200 SDRAM.
CPU watchdog capability is also supported. Manual Organization Chapter 1: Introduction The first chapter provides a checklist of the main components included with the server system and describes the main features of the SUPER P3TDDR mainboard and the SC810 chassis, which make up the SuperServer 6011D. Chapter 2: Server Installation This chapter describes the steps necessary to install the SuperServer 6011D into a rack and check out the server configuration prior to powering up the system. If your server was ordered without processor and memory components, this chapter will refer you to the appropriate sections of the manual for their installation. Chapter 3:
System Interface Refer here for details on the system interface, which includes the functions and information provided by the control panel on the chassis as well as other LEDs located throughout the system. iii