Chapter 5: Maintenance 5.6 Enabling Pendant Messages You can disable all error messages except the Connection Lost screen, which is displayed if the T20 pendant ever loses connection to the SmartController EX motion controller. To enable the display of error messages on the pendant: 1. From the Home 1 screen, press Next > to display the Home 2 screen. 2. Press Maint. The System Maintenance screen opens. 3. Press the up/down arrow buttons to select the Pendant Msgs option. Press OK. 4. Press the up/down arrow buttons to select Enabled or Disabled. 5. Press OK to accept the change. Press Cancel to revert to the previous setting.
5.7 Displaying System Information The System Information screen displays identity information about components of the system, as returned by the ID monitor command. See the eV+ Operating System Reference Guide for details. Additionally, it displays the IP address of the connected controller. To access the System Information screen: 1. From the Home 1 screen, press Next > to display the Home 2 screen. 2. Press Maint. The System Maintenance screen opens. 3. From the System Maintenance screen, press the Info soft key. The following screen opens. Figure 5-2. Sample System Information Screen T20 Pendant User's Guide, 10433-000 Rev. E Page 42 of 50