Safety requirem ents EN conditions, clean the outer surface of the instrument by following the following steps: 1) Use a lint - free cloth to remove the dust outside the oscilloscope and probe. Please be careful to avoid scratching the smooth display filter material. 2) Clean the oscilloscope with a soft cloth soaked in water. For a more thorough cleaning, use a aqueous solution of 75% isopropyl alcohol. Note: In order to avoid damaging the surface of oscilloscope or probe, do not use any corrosive reagent or chemical cleaning reagent. Warning: Before powering on the device again, ensure that the device is dry enough to avoid electrical short circuit or personal injury caused by moisture.
1.6 Environmental Considerations The following symbols indicate that the product complies with the requirements of WEEE Directive 2002/96/EC. Equipment recovery: Producing the device requires the extraction and use of natural resources. Some substances contained in the equipment may be harmful to the environment or human health if the product is not disposed of properly. In order to avoid the release of harmful substances into the environment and reduce the use of natural resources, it is recommended that appropriate methods be used to recycle this product to ensure that most of the materials can be correctly reused. Copyright © Qingdao Hantek Electronics Co., LTD Tablet1000 User manual 5