Set the horizontal system EN 5 Set the horizontal system This section contains detailed information about oscilloscope horizontal systems. You are advised to read carefully in order to understand its settings, functions and operations. The following figure shows the sampling rate, storage depth, primary time base and horizontal displacement. 5.1 Adjust the horizontal displacement Horizontal displacement refers to the displacement of waveform trigger points of all channels in the horizontal direction relative to the center of the screen. When the waveform trigger point is on the left (right) side of the screen center, the horizontal displacement is positive (negative).
When the horizontal displacement is changed, the waveform trigger points and displayed waveforms of all channels move left and right. The horizontal displacement at the top of the screen changes in real time, as shown in the figure below. Adjust the horizontal displacement by touch screen gestures Adjust the horizontal displacement by dragging. The horizontal trigger position icon on the screen will move along with your finger slide. You can change the position of the control trigger point relative to the center of the screen while adjusting the horizontal position of the waveforms of all analog channels roughly. For details, see the Dragging section.
5.2 Adjust the horizontal time base (time/grid) The horizontal time base is the time value represented by each grid in the horizontal direction of the display screen, generally expressed as s/div. If the horizontal time base is changed, the horizontal time base will be displayed in real time as shown below. Tablet1000 User manua l Copyright © Qingdao Hantek Electronics Co., LTD 24