Shortcuts EN 15 Shortcuts Auto setting: Auto setup of oscilloscope controls to generate useful display of input signals . See the following table for relevant information. Click Auto at the bottom of the screen, and the oscilloscope will perform Auto setting automatically. Default setting: Automatically call out the default settings. Click Utility > Default . 15.1 Auto setting Auto setting is one of the advantages of digital oscilloscopes. When you click Auto setting, the oscilloscope will recognize the waveform type (sine or square) and adjust the control mode to accurately display the waveform of the input signal.
Tablet1000 User manua l Copyright © Qingdao Hantek Electronics Co., LTD 62 Function Settings Acquisition mode Sampling or peak detection Cursor OFF Display mode YT Display type FFT spectrum is set to vector. Otherwise, no change. Horizontal position Has been adjusted SEC/DIV Has been adjusted Trigger coupling Set to DC, noise suppression, or high frequency suppression Trigger hold-off 20ns Trigger level 50% Trigger mode Automatic Trigger source Has been adjusted. Automatic setting cannot be used for external trigger signals.
Trigger slope Has been adjusted Trigger type Edge Video Has been adjusted synchronizatio n trigger Video trigger Has been adjusted standard Vertical bandwidth All Vertical coupling DC (if GND was previously selected). For video signals, set it to AC. Otherwise, no change.