Signal source EN 17 Signal source Click [ AFG ] to enter the signal source interface. Users can edit any waveform or select sine wave, square wave, triangle wave, noise, DC and arbitrary waveforms. Figure 17.1 Signal source 17.1 Set the output waveform type and parameters 1. Enter the Signal source interface. 2. Select the desired Waveform on the right and click Confirm. Click Next to set extra arbitrary waves. 3. Click Frequency to set the frequency. Click it again to set the Period . Click the 4. Click Amplitude to set the amplitude. Click it again to set the high level (the offset number to call out the numeric keypad to set the value. is automatically switched to the low level).
Click the number to call out the numeric keypad to set the value. 5. Click Offset to set the offset. Click it again to set the low level (the amplitude is automatically switched to the high level). Click the number to call out the numeric keypad to set the value. 6. Click Phase to set the phase. Click the number to call out the numeric keypad to set the value. 7. Click Duty cycle to set the duty cycle of the square wave. 8. Click Symmetry to set the symmetry of the triangle wave. 9. Click High-Z repeatedly to set the output load impedance of the waveform generator. The default value is 50Ω. Tablet1000 User manua l Copyright © Qingdao Hantek Electronics Co., LTD 68