en 27 Display messages 3. Pull the power cord out of the storage compartment (20) and plug in. Adjust the length of the cable by pushing it back in or pulling it out. The easiest way to do this is to place the appliance so that its back is fl ush with the edge of the counter and either pull the cable down- ward or push it upward . 4. Install the milk frother. Operate the machine only after the milk frother (6) has been fully assembled and installed. The display (15) shows not only the current operating status, but also various mes- sages that give you status information or let you know when you need to take action.
As soon as you have taken the necessary action, the message disappears and the menu for drink selection is displayed again. Before using for the fi rst time General Fill the water tank with fresh, cold, uncar- bonated water only, and preferably use only beans for fully automatic coffee and espresso machines. Do not use coffee beans that have been glazed, caramelised or treated with other additives containing sugar, since they will block the brewing unit. The water hardness setting can be adjusted on this appliance. The factory default setting for the water hardness is 4. Check the water hardness with the enclosed test strip.
If the check reveals a value other than 4, change the setting on the appliance accord- ingly after switching on (see “Menu settings” Water hardness on page 30). 5. Lift the lid of the water tank (17). 6. Remove and rinse the water tank (16) and fi ll it with fresh cold water. Do not fi ll above the max mark. 7. Replace the water tank (16) and push it fi rmly downward into place. 8. Close the lid of the water tank (17) again. 9. Fill the bean container (1) with coffee beans. (For preparation using ground coffee, see “Preparation using ground coffee” on page 31.) 10. Press the power switch O / I (9). The display (15) shows the menu for setting the display language. 11.
Select the required display language with the upper rotary knob (14). The following languages are available: русский English 12. Press the start button (10). The language you selected is saved. The display shows Pull milk frother . 13. Place a receptacle under outlet. 14. Carefully pull out the milk frother (6) to open it. The appliance rinses out the milk frother (6) with water. The display shows Push milk frother . Switching on the appliance 1. Remove the protective fi lm. 2. Place the fully automatic espresso machine on a fl at, water-resistant surface that can take its weight. Make sure that the machine’s ventilation slots remain unobstructured. Important:
Only use the appliance in frost-free rooms. If the appliance has been transported or stored at temperatures below 0 °C, wait at least 3 hours before operation. TES552... | 05/2013 TES55236RU.indb 27 04.06.2013 14:35:44