en 13 Contrast The display 5 contrast can be set from –10 to +10 . The factory setting is +0 . ●Turn the rotary knob 6 to select the required setting. Water filter A new water fi lter 29 must be rinsed before it can be used. ●To do this, press the water fi lter 29 fi rmly into the water tank 11 with the aid of the measuring spoon 14 . Fill the water tank with water up to the “ max ” mark. ●Turn the rotary knob 6 to select start and press the start button 8 . Place 1 l container Place suction pipe in container start ●Place a container with a capacity of 1 litre under the milk frother 10 . ●Place the end of the suction pipe 10d in the container. ●Press the start button 8 .
Water will now fl ow through the fi lter 29 to rinse it. ●Next, empty the container. The appliance is ready for use again. Water hardness ●Turn the rotary knob 6 to select the required water hardness 1, 2, 3 or 4 . Info: It is important to set the water hard- ness correctly, so that the appliance indi- cates accurately when the descaling pro- gramme should be run. The factory setting for the water hardness is 4 . You can check the water hardness using the enclosed test strip or by asking your local water supplier. ●Dip the test strip briefl y in water and check the result after one minute.
Level Water hardness German (°dH) French (°fH) 1 2 3 4 1-7 8-14 15-21 22-30 1-13 14-25 26-38 39-54 Info: Rinsing the fi lter 29 simultaneously activates the setting for the “change fi lter” display. You can fi nd detailed information about the water fi lter in the enclosed fi lter instructions. The fi lter 29 is no longer effective when the Service - change filter display appears, or at the latest after two months. It needs to be replaced for reasons of hygiene and so that there is no build-up of limescale (this could damage the appliance). Replacement fi lters can be obtained from retailers (TCZ7003) or from customer service (575491). TES80..
| 04/2013 TES803_805_807_1RW.indb 13 08.05.2013 14:52:59