en 21 Descaling Duration: approx. 30 minutes. ● ●Pour lukewarm water into the empty water tank 11 up to the “ 0.5 l ” mark and then dissolve two Bosch descaling tablets in it. ● ●Press the start button 8 . The descaling programme will now run for about 20 minutes. Descaling Add 0.5 l water and descaler start The start button 8 flashes while the different descaling processes are running. The figures on the top right indicate the progress of the programme. Not enough descaling fluid. Refill fluid start Info: If there is not enough descaling solu- tion in the water tank 11 , the corresponding prompt is displayed. Pour in descaling solu- tion and press the start button 8 again. Important:
If there is a water filter 29 in the water tank 11 , it needs to be removed before the service programme is run. Clean and refill water tank start ● ●Press the а button 3 . ● ●Rinse the water tank 11 and refill it with fresh water up to the “ max ” mark. ● ●Press the start button 8 . The descaling programme now runs for about 1 minute and rinses the appliance. Descaling Descale start ● ●Press the start button 8 ; the display 5 will guide you through the programme. Empty drip tray Replace drip tray Empty drip tray Replace drip tray ● ●Empty the drip tray 23 and reinsert it. ● ●Empty the drip tray 23 and reinsert it.
Place 1 l container Place suction pipe in container start Replace the filter if one is being used. The appliance is ready for use again. ● ●Place a container with 1 litre capacity under the milk frother 10 . ● ●Place the end of the suction pipe 10d in the container. ● ●Press the start button 8 . Important: Wipe down the appliance using a soft, damp cloth to immediately remove any descaler residue. Such residue can cause corrosion. New sponge cloths may contain salts. Salts can cause rust film on stainless steel and must therefore be washed out thoroughly before use. Thoroughly clean the suction pipe 10d of the milk frother. Remove filter start Info:
If the water filter 29 is activated, the display will prompt you to remove the filter 29 , then press the start button 8 again. TES80.. | 04/2013 TES803_805_807_1RW.indb 21 08.05.2013 14:53:02 Cleaning and service Descale start Clean