en 23 Place 1 l container Place suction pipe in container start Clean and refill water tank start ● ●Place a container with a capacity of at least 1 l under the milk frother 10 . ● ●Place the end of the suction pipe 10d in the container. ● ●Press the start button 8 . The appliance rinses twice. Cleaning ● ●Rinse the water tank 11 and refill it with fresh water up to the “ max ” mark. ● ●Press the start button 8 . The descaling pro- gramme now runs for about 1 minute more, followed by the cleaning programme for about 7 minutes, and rinses the appliance. Descaling Cleaning Open powder compartment ● ●Open the powder compartment 18 .
Empty drip tray Replace drip tray Insert Bosch cleaning tablet and close drawer ● ●Empty the drip tray 23 and reinsert it. ● ●Drop a Bosch cleaning tablet in the drawer 18 and close. Replace the filter if one is being used. The appliance has completed descaling and cleaning and is ready for use again. Remove filter start Info: If the water filter 29 is activated, the display will prompt you to remove the filter 29 , then press the start button 8 again. Important: Wipe down the appliance using a soft, damp cloth to immediately remove any descaler residue. Such residue can cause corrosion. New sponge cloths may contain salts.
Salts can cause rust film on stainless steel and must therefore be washed out thoroughly before use. Thoroughly clean the suction pipe 10d of the milk frother. Add 0.5 l water and descaler start ● ●Pour lukewarm water into the empty water tank 11 up to the “ 0.5 l ” mark and then dissolve two Bosch descaling tablets in it. ● ●Press the start button 8 . The descaling programme now runs for about 20 minutes. Descaling Note: If one of the service programmes is interrupted, e. g. by a power outage, pro- ceed as follows: Not enough descaling fluid. Refill fluid start Info: If there is not enough descaling solu- tion in the water tank 11 , the corresponding prompt is displayed.
Pour in descaling solu- tion and press the start button 8 again. ● ●Rinse the water tank 11 and refill it with fresh water up to the “ max ” mark. ● ●Press the start button 8 . The cleaning programme now runs for about 3 minutes, and rinses the appliance. Cleaning Empty drip tray Replace drip tray ● ●Empty the drip tray 23 and reinsert it. The appliance is ready for use again. TES80.. | 04/2013 TES803_805_807_1RW.indb 23 08.05.2013 14:53:03