Chapter 4 Handling Status Sheet Printing (Ethernet model only) Following status sheet is printed when pressing the status sheet button on the rear of the printer. Network setting can be checked by printing the status sheet for the Ethernet model. The network setting can be reset to the default value by turning on the printer while pressing the status sheet button and holding the button down for 20 seconds or more.
Auto (10 Base Full/10 Base Half/100 Base Full/ 100 Base Half)/10 Base Full/10 Base Half/100 Base Full/100 Base Half Auto/MDI/MDI-X Auto/Manual Enable/Disable Enable/Disable Enable/Disable 4 Enable/Disable Enable/Disable Enable/Disable Enable/Disable Enable/Disable Enable/Disable 193 EPSON Network Status Sheet 1. MAC Address XX : XX : XX : XX : XX : XX 2. HW/SW Version XX . XX/XX . XX 3. Network Status Auto (100Base Full) 4. Port Type Auto 5. Get IP Address Manual 6. IP Address XXX . XXX . XXX . XXX 7. Subnet Mask XXX . XXX . XXX . XXX 8. Default Gateway XXX . XXX . XXX . XXX 9. APIPA Disable 10. Set using PING Disable 11. DNS Address Disable XXX . XXX . XXX . XXX XXX . XXX . XXX . XXX XXX .
XXX . XXX . XXX 12. UPnP Disable 13. Bonjour Disable 14. Port Control LPR Enable Port 9100 Enable 15. Printing Control Disable 16. Time Server Disable 17. Idle Timeout LPR XXXX sec Port 9100 XXXX sec