Procedure for replacing the printer (1) Connect the new printer to the administrator computer and turn on the printer. (2) Configure the existing printer settings in the printer. The USB serial number in the printer setting file for the existing printer will be the USB serial number of the new printer. Set the printer’s DIP switches to match the DIP switch setting information of the existing printer. (Refer to "Setup Procedure" on page 218 .) (3) Remove the existing printer from the client computer. (4) Connect the new printer to the client computer and turn on the printer.
Ethernet model Configure the IP address and other network settings of the existing printer and the settings of the existing printer in the new printer. There is no need to configure the printer driver on the client computer. Preparation The network setting information of the existing printer (IP address and so on) Print the status sheet with the existing printer. (See "Status Sheet Printing (Ethernet model only)" on page 193 .) The printer setting file of the existing printer Confirm the DIP switch setting for the existing printer. Replacing procedure (1) Set the new printer’s DIP switch settings to the same as that of the existing printer.
(2) Connect the new printer to the network, and turn it on. (3) Make the network setting for the new printer according to the printed status sheet using EpsonNet Config. (4) Make the setting to the new printer using the printer setting file with the Printer Setting. 232