Chapter 1 Overview and Basic Operations Parts Name and Function This section describes the name and function of each part in the product. Front 4 3 2 1 Lights when the paper is not installed or is not correctly installed. Off when the paper is correctly installed. 1 5 6 7 Push this button to cut the roll paper. 8 9 Push this button to feed the roll paper. 11 Pull to open the roll paper cover. 10 Open to set/replace the ink cartridge. Open to set/replace the paper. 12 Lights when there is no error. Flashes when the printer is operating (initializing, head cleaning, or printing) or in an error state. Push this button to turn on/off the power of the product.
It takes 1 or 2 minutes after the power button is pressed for the printer to be on. Wait until the status LED quits flashing. It takes 40 seconds until the status LED flashes after the power button is pressed. Lights or flashes when the printer is offline, and is off when the printer is online. Lights when the power is on, and is off when the power is off. Flashes when ink is low or waste ink in the ink cartridge is nearly full. Installing the paper ejection tray enables you to accumulate printed paper temporarily in it. Lights when it is time to replace the ink cartridge, when the ink cartridge is not installed or is not correctly installed, and when waste ink in the ink cartridge is full.
Off when ink in the ink cartridge is adequate. 15 4 PAPER LED (Red) 5 CUT button 6 FEED button 7 Release lever 8 Ink cartridge cover 9 Roll paper cover 1 Status LED 10 Power button 2 ERROR LED (Red) 11 Power LED (Green) 3 Ink LED (Red) 12 Paper ejection tray