Chapter 2 Setup Installing the Printer Install the product at an appropriate place, leaving enough space around the product. If you install the product against a wall, keep the rear and sides of the product more than 10 cm from the wall. Do not block the air vents on this product. Blocking the air vents may result in internal heat build-up and fire. WARNING Install the product horizontally on a flat, stable, and vibration-free surface. Otherwise, the roll paper cover may not operate correctly, and your fingers may be caught. Do not tilt the product with the roll paper cover open. CAUTION The roll paper cover may close unexpectedly, and your fingers may be caught.
When carrying the product, be sure to hold the parts as shown in the picture below. 2 25 Installation Air vents Located on the left, right, and back. • Leave enough space for the roll paper cover, ink cartridge cover, and fanfold paper cover to be fully opened. • Protect the product from heavy impacts. They may cause defective print. • Do not allow cables to catch or foreign matter to accumulate under the product.