Chapter 2 Setup Setting the DIP Switches Change the DIP switch settings in the following cases. • When changing the power button operation • When switching the paper type between roll paper and fanfold paper (The default setting is roll paper) • When changing the volume of the buzzer Setting Procedure Follow the steps below to change the DIP switch settings. Turn the power off before removing the DIP switch cover. Otherwise, a short-circuit may cause the printer to malfunction. CAUTION DIP switch setting becomes enabled after turning the power on or completing reset by the interface. 2 1 Make sure the power supply for the printer is turned off.
2 Open the ink cartridge cover and remove the DIP switch cover. 3 Set the DIP switches, using the tip of a tool, such as a small screwdriver. 4 Attach the DIP switch cover, and close the ink cartridge cover. 33