Chapter 2 Setup Loading/Replacing the Paper Follow the steps below to load the paper for the first time, change classification or type of the paper (roll paper or fanfold paper) or replace the paper. Loading the paper is different depending of the type of the paper to use roll paper or fanfold paper. • For fanfold paper, see "Loading/Replacing Fanfold Paper" on page 49 . • For roll paper, see "Loading/Replacing the Roll Paper" on page 38 . Use paper that meets the printer specification. For details about paper specification, see "Product Specifications" on page 131 .
When exchanging paper without changing paper type, media position detection, or paper width, see "Replacing the Paper" on page 109 . Preparing the Computer When using TM-C3400Z with Ethernet connection, the procedure described in this section is not required. 2 To configure the paper settings for TM-C3400Z, network connection is required. USB connection is not available for paper setting. Therefore, when using TM-C3400Z with USB connection, TM-C3400Z and the computer must be connected with a crossover cable in order to configure the paper settings. Prepare the following items:
• Computer (with an IP address that can be changed) • Crossover cable 1 Set the IP address of the computer so that it can be connected to TM- C3400Z. Example of computer IP address setting: 192.168.192.10 The default IP address of TM-C3400Z is "192.168.192.168". 2 Connect the computer and the printer with a crossover cable. For details on how to connect the cable, see "Connecting LAN cable" on page 27 . 3 Turn on the printer. 4 Enter IP address of the printer to the address bar to the Web browser. Default setting: 192.168.192.168 Recommend the Mozilla Firefox web browser, If using the Windows Internet Explorer web browser, apply the latest security patch or Service Pack. 37