*1: In some cases, missing dots and irregularity in ink shots may occur when printing ladder barcodes, resulting in the ANSI grade being lowered to F and making barcodes unreadable. Apply an innovative method such as printing HRI characters. *2: Ink may penetrate the paper due to its characteristics, causing the bars of printed barcodes to become thicker. In such cases, reduce the data in a bar by one pixel and increase the blank space by one pixel (Adjust Bar Width). *3: The recommended values for specified media types and barcodes are as follows. For wristbands and Code 128: Five-dot module and ANSI grade D For wristbands and Codabar:
Four-dot module, minimum element ratio of 2.5, and ANSI grade C 20 General settings Print direction *1 Font settings of barcodes/2-dimensional symbols Media type Print quality Adjust Bar Width *2 Upper line: Minimum module (dot) Lower line: Minimum element ratio ANSI grade D or higher ANSI grade C or higher ANSI grade B or higher Wristbands Speed Fence Yes 3 dot 2.7 4 dot 2.5 Ladder 6 dot 2.5 *3 - *3 - Quality (Mode1) Fence 3 dot 2.7 4 dot 2.5 Ladder 6 dot 2.5 *3 - *3 - Q NOTE If an odd number value is set for the Module, changing the Media Type and Print Quality causes the resolution to change, resulting in a change in the size of the printed barcode.