Chapter 3 Handling When the printer is not found even if EpsonNet Config is started When the printer is not found even if EpsonNet Config is started, follow the steps below. 1 Restart EpsonNet Config. Exit EpsonNet Config without pressing the [Refresh] button and then start it again. 2 Wait 30 seconds. 3 If the printer is not found after 30 seconds have passed, repeat Step 1 to 2. If the problem is not solved even if the steps are repeated about 5 times, check the LAN cable connections and whether the Link LED on the lower rear side of the printer is on. See "Back" on page 15 . 3 151