Die-cut label (Blackmark) / Fanfold paper When "Borderless Printing" is disabled Top, bottom, left, right margins: 1.5 mm (Typical value) Paper feeding direction Center of paper width Perforated line Auto-cut position Interval of perforated lines (Pm) Auto-cut position Auto-cut position Perforated line Print area Label area 1.5 mm Edge cutoff 2.0 mm Backing paper Black mark position *1 When auto cut is not performed: 5.0 mm or more *2 When auto cut is not performed: 8.0 mm or more *3 When auto cut is not performed: 11.0 mm or more • Make sure to adjust perforated lines to an integral multiple of issuing pitch.
• The perforated line and print area overlap each other to destabilize printing or perforated line and the auto-cut position are misaligned to shorten the life of the autocutter if paper without black marks is used. Use paper with black marks on the back of the paper to adjust the paper position. 218 lin e tion n in e ion Paper width 0.5 to 1.5 mm 1.5 to 3 12.0 mm or more*1 Print area width 1.5 mm Edge cutoff 2.0 mm