Chapter 2 Extended I/F Specification Paper out [Input-Output] [Format] ^S(CNA, P, b [Parameter] [Function] “Paper out” signal is set to the mode that is specified by parameter b. 2 Printer status: “NO PAPER”, “NO PAPER ERROR” [Initial value] 0 [EX] "Paper out" signal is set to the mode that is low in normal status and high in paper out. ^XA ^S(CNA,P,E ^JUS ^XZ The ^JUS command is required to save settings to the non-volatile memory of the printer unit. Use a USB cable or Ethernet cable to send ESC/Label commands from the host PC. For the signal output timing, see "Timing chart" on page 20 .
11 Description Definition range b = mode D/E/0/1/2 Parameter b Mode description D/0 “Paper out” signal is not output. 1 “Paper out” signal is high in normal status and low in paper out *. E/2 “Paper out” signal is low in normal status and high in paper out *.