Chapter 2 Extended I/F Specification Pause [Input-Output] [Format] ^S(CNI, P, b [Parameter] [Function] When the “Pause” signal is input, the printer is set to the mode specified by parameter b. 2 1 Assert to the printer input (#1) requires edge input (high to low, or low to high).As the “Printer error” signal changes once the printer enters the pause status, assert the “Pause” signal before then. 2 When paused, the printer switches to unpaused. When unpaused, the printer switches to paused. [Initial value] 0 [Limitation] Printer firmware version WAI31000 or higher is required to use this function. [EX] The printer is paused while the "Pause" signal is low asserted.
^XA ^S(CNI,P,3 ^JUS ^XZ The ^JUS command is required to save settings to the non-volatile memory of the printer unit. Use a USB cable or Ethernet cable to send ESC/Label commands from the host PC. For the signal input timing, see "Timing chart" on page 20 . 13 Description Definition range b = mode 0/1/2/3/4 Parameter b Mode description 0 “Pause” signal is ignored. 1 Switches the Pause status *2 when low asserted *1 more than 20 msec or until the “Printer error” signal is not asserted for the “Pause” signal input. 2 Switches the Pause status *2 when high asserted *1 more than 20 msec or until “Printer error” signal is not asserted for the “Pause” signal input.
3 The printer is paused while the “Pause” signal is low asserted. 4 The printer is paused while the “Pause” signal is high asserted.