English With the Auto Sheet Feeder (ASF) Model With the ASF model printers, you can put up to 25 checks in the feeder guide to be fed automatically. See “Attaching the Pocket (only for the ASF model)” on page 6 for instructions on attaching the pocket, and then insert the checks. As shown in the picture below, align the checks on the right bottom corner before you insert them into the feeder guide. Note: Align the checks neatly on the bottom-right corner as shown in the image before insertion so that they will be fed one by one. If the checks are inserted without being aligned, the checks may not be fed at all, or a paper jam or incorrect feeding of multiple checks may result.
Ejecting Checks When a check is ejected and the VALIDATION/FEEDER LED flashes again, remove the check. Scanning ID Card Image Data Notes on ID Card Reading ❏ Make sure that the ID card is flat and does not have excessive bending, cracks, folds, or embossing. ❏ Do not touch the external terminal when using an IC card. ❏ Do not insert anything other than cards. ❏ Do not open any covers while an operation is in progress. In the following situations, appropriate quality of the image data is not guaranteed. ❏ When the image scanner section is exposed to sunlight, spotlights, fluorescent lights, or other excessive lights.
❏ When the glass of the scanner is damaged by sand or other foreign materials. Note on Using the Image Scanner The printer uses the image scanner to read cards. Use a USB interface because the image scanner requires it. If you use the optional UB series interface, no image data can be obtained. TM-J9000/J9100 User’s Manual 15