English Validation Printing Notes on Validation Printing ❏ Do not use paper smaller than 152 Ч 68 mm {5.98 Ч 2.68 in} (W Ч H). ❏ Do not use paper larger than 230 Ч 100 mm {9.06 Ч 3.94 in} (W Ч H). ❏ Do not use carbon paper or other multi-ply paper. ❏ Make sure that the paper has no curl, bending (especially on the corners), warpage, or wrinkles. ❏ Do not use paper with paper clips, staples, adhesive tape, or other foreign materials attached. ❏ Do not open any covers while the operation is in progress. Follow the steps below to run validation printing. 1. Wait until the VALIDATION/FEEDER LED starts flashing. 2.
From above the validation section, insert a validation paper straight into the slot, keeping the right side of the paper at the marked point shown in the following note. Note: Keep the edge of the validation paper in the position shown on the label in the picture below. 3. When the validation paper is ejected and the VALIDATION/FEEDER LED starts flashing, pull the paper straight out of the printer. Cleaning Cleaning the Print Head When printing becomes faint or uneven although the INK LED is not lit or flashing, press the CLEANING button for more than three seconds to run print head cleaning. During the cleaning process, the POWER LED keeps flashing.
When the cleaning process ends, the printer is ready for printing. TM-J9000/J9100 User’s Manual 17 Label indicati insertion positi