Appendix *1: Installed character codes vary by printer model. *2: Only the character sets installed on the printer can be printed. *3: Space between characters is not included. Characters can be scaled up to 64 times as large as the standard size. By specifying UTF-8 character encoding, all the installed character sets can be printed. For more details on printing Unicode characters, see "FS ( C" of the ESC/POS command reference, or manual of the software you use. ( "Application Development Information" on page 111 ) Auto Cutter • When taking off the cut paper, the paper is pulled at the cut position and it may cause line spacing of the next print to partially narrow.
• To prevent the uneven line spacing, when printing after paper cutting, it is recommended to advance the paper by approximately 1 mm {16/406 inch} immediately before printing. • If the paper is short in vertical length, advance the paper at least 35 mm {1.38 inch}. 121 Character size*3 Standard mode Standard/Double height/ Double width/Double height and width 42 characters mode (only when using 80 mm width paper) ANK Font A 1.50 × 3.00 mm ANK Font B 1.13 × 2.13 mm Special Font A 1.50 × 3.00 mm Special Font B 1.13 × 3.00 mm Kanji Font A 3.00 × 3.00 mm Kanji Font B Japanese: 2.50 × 3.00 Korean:
2.00 × 2.00 Special Font A 1.63 × 3.00 mm Special Font B 1.25 × 2.13 mm Kanji Font A 3.25 × 3.00 mm Barcode/ two-dimensional symbol printing UPC-A, UPC-E, JAN8 / EAN8, JAN13 / EAN13, Code39, Code93, Code128, Code128 auto, ITF, CODABAR(NW- 7), GS1-128, GS1 DataBar, PDF417, QR code, Maxi Code, Data Matrix, Aztec Code, Two-dimensional GS1 DataBar, Composite Symbology Type Detachable V-shaped blade cutter Cutting method Partial cut (cutting with one point in center left uncut)