Chapter 2 Setup SimpleAP mode This printer comes with a mode (SimpleAP) that allows printers to connect with a smart device or a computer without requiring a wireless access point. This allows you to easily setup a wireless LAN for the printer by using a printer settings tool (TM-L100 Utility, Epson TM Utility) even without a network environment such as access points. When the wireless LAN settings of the printer have not been changed from the factory default, and the printer is turned on, the printer automatically enters the Simple AP mode and prints the following information.
If you have changed the wireless LAN settings from the factory default, start the printer according to the settings to connect the printer to an access point. "Interface Setup Mode (Interface Setup)" on page 99 Serial number of the printer 52 SimpleAP Start SSID : DIRECT-TM-L100- XXXXXXXXXX Encryption Type : WPA2-PSK Passphrase : XXXXXXXXXX IP Address : 192.168.192.168 MAC Adress : XX-XX-XX-XX-XX-XX