TM-P60 Technical Reference Guide 2. To access the DIP switches, remove the DIP switch cover by hand (pull out the cover and then pull it upward to release the projection.) projection DIP switch cover DIP switch DSW 1 is fixed to OFF. Note: Serial communication setting is assigned to MemorySwitch (baud rate, parity). See the table “ Customize values” (page 2-16) for details. 3. After set the DIP switch, attach the DIP switch cover. 2.7.3 Memory Switches This printer has a set of software switches called “Memory switches“ .
The memory switch set has “Msw 8,” “Customize value,” “Serial communication condition.” The “Memory switch setting utility” can change the Memory switch set to ON or OFF as shown in the table below: Note: When you use this printer with RS-232 interface, you should adjust the “serial communication setting“ (see the table “ Serial communication” (page 2-17).) Rev. C Setup 2-15 DIP switch Handshake DSW1 DSW2 D SW3 D DTR/DSR OFF ON OFF O RTS/CTS OFF OFF ON O