TM-P60 Technical Reference Guide 2.3 Setting up the Printer The TM-P60 can be set up as indicated below. ❏ Attached to a belt. If you do so, you don’t need to follow any further printer setup instructions. ❏ Attached to a shoulder strap and carried on your shoulder. ❏ Set up on a table. Remove the belt clip if you do so. 2.3.1 Attaching the Shoulder Strap Attach the shoulder strap by following the procedures indicated on the right. CAUTION: Make sure to hang the shoulder strap only from your shoulder. In order to prevent injury, never hang it from your neck. Make sure the paper roll side is facing down when using the device vertically.
2.3.2 Setting Up on a Table Remove the belt clip on the back when setting up on a table. Remove the two screws shown in the diagram. screws CAUTION: Make sure to place the device on a horizontal surface when setting up on a table. belt clip Rev. A Setup 2-5 b