TM-P60 Technical Reference Guide 1. Slide the battery cover to open it. 2. Install the battery. 3. Close the cover. 2.5.3 Charging the battery When you charge the battery, you have a choice of two methods. ❏ Charge the battery using the exclusive battery charger (option: OT-CH60). In this method, remove the empty battery from printer; then put it onto a battery charger. For the battery charger operation, see the user’s manual of the battery charger. This method requires about 2.5 hours to charge the battery. ❏ Charge the battery from the external power supply. For this method, connect the external power supply into the printer’s connector for the external power supply.
(For instructions, see “2.5.5.1 Connecting the external power supply” (page 2-11).) During the charging, the BATT. LED comes on (color: red). When the charging is completed, the BATT. LED goes off. You can charge the battery even if the printer is turned on. However, the battery is not charged while the printer is operating. This method requires about 4 hours to charge the battery. Rev. A Setup 2-9