2.6.7 Confirming the profiles that can be used Use the Bluetooth setup tool to confirm the Bluetooth profiles that can be used. The TM-P60 supports only “SPP” (virtual serial communication). Note: “Service” may be displayed as the profile. 2.6.8 Completing the Bluetooth Connection The Bluetooth connection is complete once all setting are completed with the Bluetooth setup tool. Once communication with a device has been established, some PDAs add a connection icon to their screen. This allows the user to re-establish connection by clicking the icon. 2.7 Adjusting Various Settings This printer is able to be adjusted for the items below:
❏ DIP switch (handshake of serial communication conditions) ❏ Memory switch (buzzer on/off, status notification, serial communication conditions, paper roll width, print density, Bluetooth passkey and device name, other) ❏ Roll paper width (58mm / 60mm) Adjusting the spacer and memory switch ❏ Change the Bluetooth passkey and device name. The current settings can be confirmed by a self test. (See “3.5.1 Self test mode” (page 3-3).) Note: When you adjust these items, we recommend you to confirm the new setting. You can confirm the settings by running a self-test. See “3.5.1 Self test mode” (page 3-3) for detail.
2.7.1 How to Confirm Current Settings You can use a self-test to confirm the current settings. See “3.5.1 Self test mode” (page 3-3). 2.7.2 DIP switch This printer has DIP switches 1~4. These are located as shown in the figure below. 1. Make sure the printer is turned off. 2-14 Setup Rev. A