RF Module This equipment contains the following wireless module. Manufacturer: Seiko Epson Corporation Model Name: M224B Product Name: Bluetooth Interface board for printer USA NOTICE This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Canada This device conforms to IC, Low Power License-Exempt Radio Communication Devices (RSS-210).
The information such as Certification No., Model Name, and Manufacturer Name are described on the surface of the module. Operation is subject to the following two conditions: (1) this device may not cause interference, and L'utilisation de ce dispositif est autorisйe seulement aux conditions suivantes: (2) this device must accept any interference, including interference that may cause undesired operation of this device. (1) il ne doit pas produire de brouillage et (2) l'utilisateur du dispositif doit ktre prkt а accepter tout brouillage radioйlectrique reзu, mкme si ce brouillage est susceptible de compromettre le fonctionnement du dispositif. Caution:
Exposure to Radio Frequency Radiation To comply with IC RF exposure compliance requirements, this device must not be co-located or operating in conjunction with any other antenna or transmitter. vi Rev. A