Q2. Can the buzzer be set not to sound? A2.1 Change the memory switch settings. You can set the memory switch settings so that the buzzer does not sound. See “ Memory Switches ” (page 2-15) for details regarding the memory switch. Q3. The battery LED is illuminated or blinking. What should I do? A 3.1 he battery doesn't have a charge. Check the battery LED status to confirm the battery level. (See “ About the Battery Remaining Amount ” (page 4-2)). See “ Charging the battery ” (page 2-9) for battery charging procedures. Q4. The power LED is slowly blinking. What should I do? A 4.1 Check the TM-P60 and host device’s Bluetooth settings.
Use a utility to confirm the host device’s Bluetooth settings. Print the TM-P60 self test to confirm if the device is recognized. The passkey, device name, and Bluetooth address are printed on the self test. See “ To Confirm the Current Setting of the Printer ” (page 3-3) for details on how to print a self test. A 4.2 Check that the TM-P60 is within Bluetooth communication range. The host device may not be within communication range. If there are any objects between the host device and the TM-P60, move the TM-P60 and check to see if the LED has stopped blinking. Q5. I cannot connect the TM-P60 to Bluetooth. What should I do? A 5.1 Check the TM-P60 and host device’s Bluetooth settings.
Use a utility to confirm the host device’s Bluetooth settings. Print a TM-P60 self test to confirm if the device is recognized. The passkey, device name, and Bluetooth address are printed on the self test. See “ To Confirm the Current Setting of the Printer ” (page 3-3) for details on how to print a self test. A 5.2 Another network is causing radio wave interference. Radio wave interference can occur if a wireless LAN network is operating in the same area. Move the devices to a different area if this is the case. A 5.3 There is a noise source near the TM-P60. Communication may be impeded if a microwave oven or motor is operating in the same vicinity.
Move the host device or TM-P60 and check that communication is possible farther away from the noise source. A 5.4 Check that the TM-P60 power is On. Turn on power to the TM-P60 device. C-2 FAQ Rev. A