Connecting the Scanner to the Host Computer Follow these steps to connect the scanner to a host computer. 1 Confirm that the scanner is not connected to the host computer. 2 Install the TM-S1000 driver. If the scanner is connected to a host computer before the driver is installed, the Found New Hardware Wizard will be displayed. In that case, cancel the wizard and install the driver. 3 After installing the driver, connect the scanner to the host computer via the USB cable. Be sure to use the USB cable that is included with the scanner. Hook the USB cable on the USB cable securing hook as shown in the figure below to prevent the cable from falling off.
USB cable securing hook USB cable USB connector 40