Chapter 3 Advanced Usage Printing a Status Sheet Follow the steps below to check the Ethernet interface settings. When the power LED is flashing, wait until it remains lit to start printing. Using the Status Sheet Button 1 Check that the printer is turned on. Make sure the roll paper cover is closed. 2 Hold down the status sheet button (for 3 seconds or longer). The status sheet is printed. After printing, the printer returns to the standard mode. Using the Feed button 1 Check that the printer is turned on. 2 Open the roll paper cover. 3 Hold down the Feed button (for 1 seconds or longer). 4 Close the roll paper cover. The status sheet is printed.
After printing, the printer returns to the standard mode. * * * Ethernet Interface * * * Ethernet Status MAC Address Physical Layer Link Status : XX-XX-XX-XX-XX-XX : Auto-negotiation : Connect Ethernet : XXXXXXXXXXXX : WF DN TM-T100 Network Soft Version : XX.XX TCP/IP Status Acquiring IP Address Subnet Mask Default Gateway : : XXX.XXX.XXX.XX : XXX.XXX.XXX.X : X.X.X.X XXXX Other Status TimeServer Stored Date/Time : Invalid : 20XX/XX/XX 00:00:00 42