Chapter 2 Setup Connecting the Ethernet interface cable • When LAN cables are installed outdoors, make sure devices without proper surge protection are cushioned by being connected through devices that do have surge protection. Otherwise, the devices can be damaged by lightning. • Never attempt to connect the customer display cable, drawer kick-out cable, or a standard telephone line cable to the 10/100BASE-T LAN connector. CAUTION To use the Ethernet interface, the IP Address Setup Utility for UB-E03 is required.
For detailed information about the setup methods, see “Setting IP Address Using EPSON TMNet WinConfig“, “Setting IP Address Using arp/ping Command“, “Checking/Changing the Settings“, “Initializing“, and “ESPON TMNet WebConfig” in the UB-E03 Technical Reference Guide. You can obtain the IP Address Setup Utility for UB-E03 and the UB-E03 Technical Reference Guide from one of the following URLs or ask your dealer: • For customers in North America, go to the following web site: www.epson.com/support/ • For customers in other countries and regions, go to the following web site:
www.epson-pos.com/ 2 Connect a 10/100BASE-T cable to the 10/100BASE-T LAN connector by pressing firmly until the connector clicks into place. LED (Green) LED (Yellow) Button 10/100BASE-T LAN interface connector Press down the button for a while when the power is on to initialize to the factory settings. 41