*The default setting for the password varies depending on the network firmware version. Network firmware version Password Before 1.10 None 1.10 or later Product serial number (10 alphanumeric characters, case sensitive) You can check the network firmware version using the self-test ( " Self-test Mode " on page 68 ). You can check the product's serial number on the manufacturing nameplate attached to the product.
88 Article Parameters Default values Utility Browser Status sheet print View Setting View Setting IP address 192.168.192.168 Yes Yes Yes Yes Yes Subnet mask 255.255.255.0 Yes Yes Yes Yes Yes Gateway address 0.0.0.0 Yes Yes Yes Yes Yes DHCP Enable/Disable Disable Yes Yes Yes Yes Yes APIPA Enable/Disable Disable Yes Yes Yes Yes Yes Arp/ping IP setting Enable/Disable Enable Yes Yes Yes Yes No Community name 1 (read-only) Max. 16 characters “public” Yes No Yes No Yes Community name 2 (read-write) Max. 16 characters None Yes Yes Yes Yes Yes IP Trap 1 Enable Enable/Disable Disable Yes Yes Yes Yes No IP Trap 2 Enable Enable/Disable Disable Yes Yes Yes Yes No Community name (IP Trap #1) Max.
16 characters None Yes Yes Yes Yes No Community name (IP Trap #2) Max. 16 characters None Yes Yes Yes Yes No IP trap #1 address None Yes Yes Yes Yes No IP trap #2 address None Yes Yes Yes Yes No Socket timeout 0: No timeout 1-300: duration of timeout (seconds) 300 No No Yes Yes Yes Password None or the product serial number (10 alphanumeric characters, case sensitive)* No Yes No Yes No Mode name Auto negotiation /10Base-T Half /10Base-T Full /100Base-TX Half /100Base-TX Full Auto negotiation Yes Yes Yes Yes Yes Hardware version — — Yes No Yes No Yes Firmware version — — Yes No Yes No Yes MAC address — — Yes No Yes No Yes