Chapter 2 Setup • If the host computer and the printer are not connected on a continuous basis but rather connected every time the printer starts printing, some time may be needed for the printer to actually start printing after the host computer commands printing. This pause is the time required for processing the connection between the host computer and the printer, and it depends on the conditions of the environment where used. • If data transfer from an application of the host computer has already been completed, data might remain in the Bluetooth module internal buffer.
As such data remaining in the buffer might be lost when the connection is cut off, use the status or similar functions to check that transmitted data has been completely printed before cutting off the wireless connection. Setting up from a Windows Computer • For detailed information about EPSON TM Bluetooth ® Connector, see the TM Bluetooth ® Connector User’s Manual. • The device name and passkey are editable with the Setup Utilities. • The Bluetooth security level has been set to "Low" by default. For information on the Bluetooth security settings, see "Interface Setup Mode" on page 76 . • The pairing information of up to 8 devices can be registered.
(Multi-pairing is supported.) If the maximum number is exceeded, the oldest pairing information will be discarded. • Only one device can be connected at a time. (Multi-point connection is not supported.) 2 Follow the procedure below and make the settings. 1 Have a Bluetooth wireless technology compatible computer ready. Make sure you have installed TM Bluetooth ® Connector. 2 Turn on the printer. 3 Start TM Bluetooth ® Connector. 4 Select [Search all printers around this computer], and then click [Search]. 37