Chapter 3 Advanced Usage Advanced Usage Setting the DIP Switches On this printer, you can make various settings with DIP switches. The DIP switches are already set for the current interfaces. Change the setting if necessary. Functions of the DIP switches differ depending on the interface. For models with the buzzer function, see also "Setting the Built-in Buzzer (for Model with a Built-in Follow the steps below to change the DIP switch settings. • Before you remove the DIP switch cover, turn off the printer and disconnect all cables. Otherwise, a short-circuit may cause the printer to malfunction.
• If you open the DIP switch cover, be sure to close the cover and tighten the screw after adjusting the DIP switch. Using this product with the cover open may cause fire or electric shock. CAUTION 3 • DIP switch settings are enabled only when the power is turned on or the printer is reset via the interface. If the settings are changed after that, the functions will not change. • Do not change switches that are fixed to ON or OFF. Otherwise, the printer may not operate normally. 1 Make sure the printer is turned off. 2 Unscrew the screw to remove the DIP switch cover from the base of the printer.
DSW2 (DIP switch 2) DIP switch on the buzzer substrate (Only on models with a built-in buzzer) DSW1 (DIP switch 1) 53 Buzzer)" on page 43. Setting Procedure