Chapter 2 Setup For Parallel Interface DIP switch bank 1 DIP switch bank 2 If you turn on DIP switch 2-7 or 2-8 while the printer power is turned on, the printer may be reset, depending on the signal state. DIP switches should not be changed while the printer power is on. 2 For DIP switch 2-1 (BUSY condition), see also "Selecting the BUSY Status" on page 30 .
29 SW Function ON OFF Factory setting 1-1 Auto line feed Always enabled Always disabled OFF 1-2 Receive buffer capacity 69 bytes 4 KB OFF 1-3 ~ 1-8 Undefined — — OFF SW Function ON OFF Factory setting 2-1 Handshaking (BUSY condition) Receive buffer full Reading data Offline Receive buffer full Reading data OFF 2-2 Reserved (Do not change settings) Fixed to OFF OFF 2-3 ~ 2-4 Undefined — — OFF 2-5 ~ 2-7 Reserved (Do not change settings) Fixed to OFF OFF 2-8 IF pin 31 reset signal (Do not change settings) Fixed to ON ON