5 Start Up ‹ Drive Setup Procedure The illustration below shows the basic setup procedure. Each step is explained more detailed on the following pages. START Intstall and wire the drive as explained. Turn the power on. Initialize the drive if necessary using parameter A1-01. * b1-01, b1-02 for frequency reference and RUN command source * H1- , H2- , H3- , H4- , to configure the I/Os * Frequency reference values * C1- , C2- for Acceleration/Deceleration times and S-curves * E1- , E2- V/f pattern and motor data Set/check the basic parameters: Run the motor without load, check the operation and verify, if the upper controller (e.g.
PLC,...) commands to the drive work as desired. Connect the load, run the motor and check the operation Fine tune and set application parameters if necessary. Final check the operation and verify the settings. Drive is ready to run the application 18 I80E-EN J1000 Quick Start Guide 5 Start Up