2. PRINTER SETUP ENGLISH VERSION EO1-33094 2.3 Loading Supplies 2.3.1 Loading the Media (Cont.) 10. Lower the Print Head Block. 11. Once the media is loaded it may be necessary to set the Media Sensors used to detect the start position for label or tag. Setting the Feed Gap Sensor position (1) Manually move the Media Sensor so that the Feed Gap Sensor is positioned at the centre of the labels. ( indicates the position of the Feed Gap Sensor). Setting the Black Mark Sensor position Gap Label Media Sensor Feed Gap Sensor ( ) NOTE: Be sure to set the black mark sensor to detect the centre of the black mark, otherwise a paper jam or no paper error may occur.
(1) Pull about 500 mm of media out of the front of the printer, turn the media back on itself and feed it under the Print Head past the sensor so that the black mark can be seen from above. (2) Manually move the Media Sensor so that the Black Mark Sensor is in line with the centre of the black mark on the media. ( indicates the position of the Black Mark Sensor). Black Mark Black Mark Sensor ( ) Media Media Sensor E2- 7