2. Press FN+F2 to start the System Configuration utility. 3. Choose Passwords from the System menu, then choose Set Admin Password. 4. Type your new password—it can contain up to eight characters—then press TAB . The display shows * for each character in your password. Leave the box empty if you want no password. Hint: Before you type a password, check the status of Num Lock—normally, you’d want it off so you can type letters. 5. Type the new password again (in the Verify line), then choose OK. 6. Choose Passwords from the System menu, then choose Password option. 7. Select or clear the Administrator Password Required options you want—they’re explained below—then choose OK. 8.
Choose Save and Reboot from the Exit menu, then choose OK in the Save and Reboot dialog box. You have two choices for password security, as indicated by the Administrator Password Required options: Save modifications to PC ID texts You must enter your administrator password every time you save changes to the PC identification. Save Setup changes You must enter your administrator password every time you save changes in the System Configuration utility or OmniBook Tools. 27