To prepare your OmniBook for SCSI devices 2. In the C:\CONFIG.SYS file, remove the rem characters from the INCLUDE=SCSI line. 1. Save any open files—you will be rebooting your computer. Connecting SCSI Devices 3. Exit Windows if necessary, then press CTRL+ALT+DEL to reboot your OmniBook. Connecting SCSI Devices To connect a CD-ROM drive or other SCSI device, first turn off your OmniBook, then connect the device. When you turn on your OmniBook, Windows automatically detects the new device and sets it up. If necessary, Windows requests information about the device. To connect SCSI devices 1. Make sure that each SCSI device is set to a different SCSI ID number, ID 0 through ID 6.
See the device’s documentation for instructions for checking and changing the device’s ID. 2. Set the SCSI bus termination for each device. The device at the end of the SCSI bus must be terminated, while the devices in the middle of the bus must have their terminators removed or disabled. The device’s documentation describes how to check and change the termination. 3. Connect the devices to the OmniBook, following these guidelines: • Connect the peripheral devices one after the other—a “daisy-chain” connection. • Be certain to place the terminated device at the end of the SCSI bus. 4. Plug each SCSI device into a proper electrical outlet. See the device’s documentation for details. 34