User Manual of EM760 High-Performance Inverter 160 F18.03 Estimate feedback frequency Display the estimated feedback frequency in the SVC control mode. Scope: 0.00 to upper frequency limit. *: This parameter will be updated promptly in the SVC control mode. Hz F18.04 Output torque Display the current output torque ofthe inverter. Scope: -200.0 - 200.0. % F18.05 Torque setting Display the current set torque of the inverter. Scope: -200.0 - 200.0. *: This parameter will be updated promptly in the torque control mode. % F18.06 Output current Display the current output current of the inverter. Depending on the rated power level ofthe motor, the range is as follows:
0.00 to 650.00 (rated power of motor: ≤75 kW) 0.0 to 6500.0 (rated power of motor: > 75 kW) A F18.07 Output current percentage Display the current output current as a percentage (relative to the rated current of the inverter). Range: 0.0 to 300.0. % F18.08 Output voltage Display the current output voltage ofthe inverter. Scope: 0.0 - 690.0. V F18.09 DC bus voltage Display the current bus voltage. Scope: 0 - 1200. V F18.10 Simple PLC running times When the auxiliary frequency source B is involved in setting (F00.06 ≠ 0), the setting mode is “11: simple PLC” (F00.05=11) and the simple PLC runs in the mode of limited cycles (F08.15=1/2), the real-time number of cycles will be displayed.
“0” indicates that the first operation is being performed, and “1” indicates that the first operation has been completed and the second operation is being carried out. Range 0 - F08.16. : F18.11 Simple PLC operation stage When the auxiliary frequency source B is involved in setting (F00.06 ≠ 0), and the setting mode is “11: simple PLC” (F00.05=11), the real-time PLC running status will be displayed. Scope: 1-15, corresponding to the multi-segment speed 1 (F08.00) to multi-segment speed 15 (F08.14). F18.12 PLC running time at the current stage When the auxiliary frequency source B is involved in setting (F00.06 ≠ 0) and the setting mode is “11:
simple PLC” (F00.05=11), the PLC running time at the current stage will be displayed in a real-time manner. Scope: 0.0 to the set time of the corresponding segment (example: the time of the first segment is dependent on F08.20). S / min F18.13 Reserved F18.14 Load rate Display the current load speed. For the correct display, please set the load speed display factor (F12.09). Scope: 0 - 65535. rpm F18.15 UP/DOWN offset frequency Display the UP/DOWN offset frequency. See 6.2.2.6 for interpretation. Hz