User Manual of EM760 High-Performance Inverter 5.5 Start and Stop Control F00.02=0: keyboard control The start and stop ofthe inverter are controlled by the RUN key, STOP key on the keyboard. In the case ofno trip protection, press the RUN key to enter the running status. Ifthe strip LED indicator above the RUN key is solidly ON, it indicates that the inverter is in the running state. If it flickers, it means that the inverter is decelerating to stop. F00.02=1: terminal control The inverter start and stop are controlled by the start and stop control terminals defined by the function code F02 . 00 to F02.06. Terminal control is dependent on F00.03. F00.02=2:
communication control The inverter start and stop are controlled by the host through the RS485 communication port. F04.00=0: direct start The inverter is started at the starting frequency, following the DC braking (not suitable when F04.04=0) and pre-excitation (not suitable when F04.07=0). The starting frequency will change to the set frequency after the holding time. F04.00=1: start with speed tracking The inverter is smoothly started at the current rotating frequency of the motor, following the speed tracking. F04.19=0: deceleration to stop The motor decelerates to stop according to the deceleration time set in the system. F04.19=1:
free stop When there is a valid stop command, the inverter will stop output immediately, and the motor will freely coast to stop. The stop time depends on the inertia of the motor and load. Terminal RUN: Xi terminal is set to “1: terminal RUN” Terminal F/R: Xi terminal is set to “2: running direction F/R” Terminal control can be divided into two types: two-line control and three-line control. 67 Function code Function codename Parameter description Default setting Attribute F00.03 Options of terminal control mode 0: terminal RUN (running) and F/R (forward/reverse) 1: terminal RUN (forward) and F/R (reverse) 2: terminal RUN (forward), Xi (stop) and F/R (reverse) 3:
terminal RUN (running), Xi (stop) and F/R (forward/reverse) 0 〇