4-2 Function Mode Multi-function Output Selection 4 Functions •You can allocate the following functions to multi-function output terminals P1, P2 and the relay output terminals. •Multi-function output terminals P1 to P2 provide open-collector output. The relay output terminal provides SPDT contact relay output. •You can select NO- or NC-contact output for each output terminal with C031 to C032 or C036. Signal During RUN This function outputs a signal while the Inverter is running. 4-53 Parameter No. Function name Data Default setting Unit C021 Multi-function output terminal P1 selection 00: RUN (signal during RUN) 01: FA1 (constant speed arrival signal) 02:
FA2 (over set frequency arrival signal) 03: OL (overload warning) 04: OD (excessive PID deviation) 05: AL (alarm output) 06: Dc (disconnection detected) 07: FBV (PID FB status output) 08: NDc (network error) 09: LOG (logic operation output) 10: ODc (communication option disconnected) 00 C022 Multi-function output terminal P2 selection 01 C026 Relay output (MA, MB) function selection 05 Data Description Reference item Page 00 RUN: Signal during RUN Signal during RUN 4-53 01 FA1: Constant speed arrival signal Frequency arrival signal 4-54 02 FA2: Over set frequency arrival signal 03 OL: Overload warning Overload limit/Overload warning 4-55 04 OD:
Excessive PID deviation PID function 4-56 05 AL: Alarm output 4-56 06 DC: Disconnection detection External analog input disconnection detection 4-57 07 FBV: PID FB status output PID function 4-58 08 NDC: Network error Network error 4-58 09 LOG: Logic operation output Logic operation function 4-59 10 ODc: Communication option disconnected Network signal error 4-59 Data Symbol Function name Status Description 00 RUN Signal during RUN ON The Inverter is in RUN mode. OFF The Inverter is in STOP mode. Available input terminals P1-PC, P2-PC, MA-MC (or MB-MC) Required settings C021, C022, C026