4-2 Function Mode „ User Setting •Displays only the parameters optionally set in U001 to U012. •In addition to U001 to U012, d001, F001 and b037 are displayed. „ Data Comparison Display 4 •Displays only the parameters changed from the factory default. Note that analog input adjustments C081, C082, C083, C121, C122, and C123, and thermistor adjustment C085 are not displayed. •All monitors (d***) and F001 are displayed. Functions „ Basic Display •Displays basic parameters. (Factory default) •Below are the parameters displayed when this function is enabled. 4-55 No.
Display requirements Parameters displayed when the requirements are met 52 Any of C021 to C026 = 37 C154 to C156 53 Any of C021 to C026 = 38 C157 to C159 54 Any of C021 to C026 = 42 C064 No. Data Function name No.
Data Function name 1 d001 to d104 Monitor display 16 A045 Output voltage gain 2 F001 Output frequency setting/monitor 17 A085 RUN mode selection 3 F002 Acceleration time 1 18 b001 Retry selection 4 F003 Deceleration time 1 19 b002 Allowable momentary power interruption time 5 F004 Operator rotation direction selection 20 b008 Trip retry selection 6 A001 Frequency reference selection 21 b011 Trip retry wait time 7 A002 RUN command selection 22 b037 Display selection 8 A003 Base frequency 23 b083 Carrier frequency 9 A004 Maximum frequency 24 b084 Initialization selection 10 A005 FV/FI selection 25 b130 Overvoltage protection function selection during deceleration 11 A020 Multi-step speed reference 0 26 b131 Overvoltage protection level during deceleration 12 A021 Multi-step speed reference 1 27 C021 Multi-function output terminal P1 selection 13 A022 Multi-step speed reference 2 28 C022 Multi-function output terminal P2 selection 14 A023 Multi-step speed reference 3 29 C036 Relay output (MA, MB) contact 15 A044 V/f characteristics selection Related functions U001 to U012