3-3 Test Run Operation Parameter Initialization •Initialize the parameters using the following procedure. •To initialize the parameters, set parameter b084 to "02". 3 Operation 3-7 Key sequence Display example Description k0.0 Power On bk-k-k- Press the Mode key once, and then press the Decrement key three times to display "b---". bk0k0k1 Press the Mode key. "b001" is displayed. bk0k8k4 Use the Increment or Decrement key to display "b084". 0k0 Press the Mode key. The set value in "b084" is displayed. 0k2 Use the Increment or Decrement key to display "02". bk0k8k4 Press the Enter key. The set value is entered and "b084" is displayed.
Press the STOP/RESET key while holding down the Mode and Decrement keys simultaneously. When the display blinks, release the STOP/RESET key first, and then the Mode and Decrement keys. =k.k0k0 Displays initialization. (In 1 s) dk0k0k1 The parameter number is displayed again in approximately 1 s.