3-6 Parameter Transition 5. Change the 1st digit of the extended function code. • "1" of the 1st digit blinks. ak0k2k1 3 Operation Press or ("A029" is displayed). (8 times) (2 times) *2 • "9" of the 1st digit blinks. ak0k2k9 Press . ("9" is entered.) 6. The extended function code setting is complete. • The code display "A029" selection is complete. Note: "A" of the 4th digit on the left starts to blink again when entering codes which have not been selected for display or codes not on the list.
ak0k2k9 Refer to "Display Selection" (page 4-53) , "Initial Screen Selection (Initial Screen at Power-ON)" (page 4-56) , "User Parameter Automatic Setting Function" (page 4-56) , and "Appendix Parameter List" to check the code, and enter again. 7. Press the Mode key to display the data. Use the Increment/Decrement keys to change the data and press the Enter key to set it. * 4 The data can be set in the same procedure as 1 to 6. * 3 * 4 * 1 This operation is available even if code "d001" is not displayed. * 2 If pressing the Mode key while each digit is blinking, the display returns the status for the 1-digit higher entry.
* 3 If pressing the Mode key while the 4th digit on the left is blinking, the values under entry are canceled and the display returns to the status before pressing the Increment and Decrement keys simultaneously in 1. * 4 To change the data, be sure to press the Mode key. 3-18