i. When AutoVISION or Visionscape start up, the AVPBackplane will run and will automatically scan all NICs for GigE cameras. The AVPBackplane will then automatically set the IP and Subnet of each camera to match the NIC is it found on. The IP address for the camera will be the same as the NIC, except incremented by one. Example: Setting NICs for Two-Camera System Setup NIC 1 for Camera 1 a. Set NIC address to 192.168.10.2 (255.255.255.0). b. The camera will automatically be given the address 192.168.10.3 (255.255.255.0) AutoVISION/Visionscape starts. Setup NIC 2 for Camera 2 a. Set NIC address to 192.168.20.2 (255.255.255.0). b.
The camera will automatically be given the address 192.168.20.3 (255.255.255.0) when AutoVISION/Visionscape starts. Using Sentech STC-M Cameras with AutoVISION and Visionscape Page 7 of 32